TRS Cable Designer

USD$12.10USD$22.00

Just what you need to connect one of our TRS controllers to your Strymon® and Eventide® pedals.

Clear

Length *

SKU: N/A Category:

Description

TRS (tip ring sleeve) cables, are commonly used to connect an external switch or expression pedal to another pedal or loop controller.

We use a combination of Switchcraft, Rean and GLS ends to give you the widest selection of customisable TRS cables on the market.

 

**To measure the length of the cables you need, grab a piece of string a couple feet long, put one end of the string on the pedal jack you want your patch cable to start at.  While holding that end of the string in place, run the piece of string to the next pedal in your signal chain.  Measure the length of string you just used for that connection.  Record the length, along with the jacks you would like to use for that particular cable (pancake, right angle or short-body straight) and repeat for the next pedal in your chain.  

When doing this, make sure to leave room for the string/cable to run around corners without being stretched too tight.  Check out our Instagram account to get an idea of how to run corners, lay cable and select jacks.  Always leave an extra couple of inches if you are cutting it close on length.  The last thing you want is a cable that is slightly too short! 

Feel free to visit our Contact Page if you can’t find something you’re after.

Warranty Information

Additional information

Weight N/A
End 1

Right Angle, Straight, Pancake

End 2

Right Angle, Straight, Pancake

Length

4", 5", 6", 7", 8", 9", 10", 11", 12", 13", 14", 15", 16", 17", 18", 19", 20", 21", 22", 23", 24", 25", 26", 27", 28", 29", 30", 31", 32", 33", 34", 35", 36"

You may also like…